Optional Gas Injection Flow Meter
During heat treating, scale forms on the surface of the steel. One way to eliminate most scaling is to wrap the steel in stainless steel foil. Another way is to install the gas injection flow meter on your furnace. It is available as either an add-on kit, or you can order the furnace with the meter installed.
The meter regulates the flow of an inert gas, such as argon, inside the furnace. The gas displaces the oxygen to prevent most scaling.
Please remember that results with the flow meter vary depending on the type of inert gas you use and your level of experience. For more details, click on the link in the Options section below.
Compare the full range of Paragon KM furnace sizes
KM-14T: 14 ½” long, 5 ½” wide, and 4 ¼” high
KM-18T: 18” long, 5 ½” wide, and 4 ¼” high
KM-24T: 24” long, 5 ½” wide, and 4 ¼” high
KM-36T: 36” long, 5 ½” wide, and 4 ¼” high
KM-45T: 45” long, 5 ½” wide, and 4 ¼” high
Double Barrel 9T: 11” long, 9” wide, and 4 ¼” high
Double Barrel 18T: 18” long, 11” wide, and 4 ¼” high
Double Barrel 24T: 24” long, 11” wide, and 4 ¼” high
Check out the accessories you can use with this kiln!
https://kilnfrog.com/collections/heat-treating-accessories